Nik Eftekhar Olivo

Foam-Cast Arch

A form-found arch built from 3D-printed PLA shells cast with an insulating mineral foam made from recycled industrial fly ash. MAS ETH DFAB thesis project.

Year
2019
Location
ETH Zürich, Switzerland
Institution
ETH Zürich, MAS ETH in Architecture and Digital Fabrication
Collaborators
Yoana Taseva, Hyunchul Kwon (tutor), Matthias Leschok (tutor)
Category
Computational Design, Material Research, Prototypes and Demonstrators
Role
Thesis project with Yoana Taseva: design, form-finding, 3D printing, casting and assembly
The assembled arch standing on a pallet outside a timber building, seen in perspective.

Project

The arch was developed as a Master’s thesis in the MAS ETH in Architecture and Digital Fabrication, together with Yoana Taseva and tutored by Hyunchul Kwon and Matthias Leschok. It explores 3D-printed formwork for a lightweight, insulating mineral foam made from recycled fly ash, an industrial by-product, supplied by the company FenX.

Design and fabrication

The geometry of the arch was obtained through form-finding and divided into a sequence of segments with interlocking ends. Each segment was 3D printed in PLA as a thin shell, then cast with the fly-ash foam. Test cubes were used to study the casting process, including perforations in the printed shell and the filling of the cavity. During casting, the shells were supported in sand. The cast segments were finally assembled into the arch.

My contribution

Thesis project with Yoana Taseva, covering design, form-finding, 3D printing, casting and assembly.

← All projects