Cadillac Pavilion
A modular dome shell for Cadillac at a classic car event in Zürich, robotically 3D printed in recycled PETG from four identical pieces, only 25 mm thin at the edges, with reinforcement programmed into the infill according to each area of the module.
- Year
- 2022
- Location
- Zürich, Switzerland
- Institution
- Nagami Design
- Client
- Cadillac
- Category
- Large-Scale 3D Printing, Computational Design, Architecture and Design
- Role
- Geometry adaptation, slicing and computational infill design

Project
A pavilion for Cadillac at a vintage classic car event in Zürich in 2022, designed and produced at Nagami. The dome shell is built from four identical, robotically 3D-printed modules that meet along their edges, leaving four arched openings between them. The aim was to make the shell as thin as possible while keeping it stable as a freestanding dome: the printed wall is only 25 mm thin at the edges.
Design and fabrication
The modules were robotically 3D printed in recycled PETG (rPETG). Because all four are identical, a single print file serves the whole dome. Adjacent modules meet through a female-female connection along their edges.
To keep the shell thin, the reinforcement is not uniform: the infill inside the printed wall was programmed computationally, so that each area of the module receives a different type of reinforcement according to its role in the shell.
My contribution
Adaptation of the geometry for fabrication, slicing, and the computational programming of the infill, assigning different types of reinforcement to different areas of the module.







Photos: Nik Eftekhar Olivo, Manuel Jiménez García